Будь ласка, використовуйте цей ідентифікатор, щоб цитувати або посилатися на цей матеріал: https://ea.donntu.edu.ua/jspui/handle/123456789/22567
Назва: ОБҐРУНТУВАННЯ СПОСОБУ ЗАХИСНОГО ЗНЕСТРУМЛЕННЯ МІСЦЯ ВИНИКНЕННЯ МІЖФАЗНОГО ДУГОУТВОРЕННЯ В МЕРЕЖІ ЖИВЛЕННЯ АСИНХРОННОГО ДВИГУНА
Інші назви: Justification of the Method of Power Supply Disconnection of Phase to Phase Electrical Arcing in the Power Network of the Induction Motor
Обоснование способа защитного обесточивания места возникновения междуфазного дугообразования в сети питания асинхронного двигателя
Автори: Ковальова, І.В.
Kovalyova, I.
Ковалёва, И.В.
Ключові слова: міжфазне дугоутворення
асинхронний двигун
двобічне знеструмлення
апарат захисту
заземлююча жила
ізоляція
междуфазное дугообразование
асинхронный двигатель
двустороннее обесточивание
аппарат защиты
заземляющая жила
изоляция
phase to phase electric arcing
induction motor
two-end power supply disconnection
protection device
ground wire
insulation
Дата публікації: 2013
Видавництво: Донецький національний технічний університет
Бібліографічний опис: Наукові праці Донецького національного технічного університету. Серія: Обчислювальна техніка та автоматизація. Випуск 1 (24). - Донецьк, ДонНТУ, 2013. С - 19-24
Короткий огляд (реферат): Досліджена комп’ютерна модель процесу міжфазного дугоутворення в мережі живлення асинхронного двигуна і отримані закономірності зміни величини струму його статора з урахуванням параметрів живлячого кабелю та відстані до місця ушкодження. Обґрунтовано спосіб визначення стану міжфазного дугоутворення з подальшим швидкодіючим двобічним знеструмленням аварійної точки силового приєднання.
Опис: Operating conditions of electromechanical equipment of mine technological section is determined by its location nonstationarity, which, in turn, makes it necessary to use of flexible cables. Phase to phase electrical arcing is the specifically view of emergency conditions in power supply of the mine section electrotechnical complex, occurs as a result of insulation damage of internal power wires by bare ground wire with increased external compression of the cable, that is determined by complex operating conditions the cable network. In this case, the resistance of an electric arc maybe comparable with the load resistance and arcing process will not be detected by overcurrent protection means. We studied computer models of the process of phase to phase electrical arcing in the power network of the induction motor and obtained the laws of the value of its stator current taking into account the parameters of the feeder cable and the distance to the fault location. We considered the way of defining the state of phase to phase electrical arcing with further fast disconnection of emergency point of power connection, which is based on determining the difference of the linear currents in three-phase induction motor stator circuit emergency network with followed disconnection of the three-phase circuits and connection one of the phase windings of the induction motor stator to its normally earthed body through the resistor. This provides a quick acting two-end power supply disconnection emergency conditions in power supply of the mine section electrotechnical complex.
URI (Уніфікований ідентифікатор ресурсу): http://ea.donntu.edu.ua/handle/123456789/22567
ISSN: 2075-4272
Розташовується у зібраннях:Випуск 1 (24)'2013
Статті кафедри ГЕА

Файли цього матеріалу:
Файл Опис РозмірФормат 
ковалева.pdf520,18 kBAdobe PDFПереглянути/Відкрити


Усі матеріали в архіві електронних ресурсів захищені авторським правом, всі права збережені.